CERLAND wooden pool liner
|
Available color: light blue, sand, white , green. 10 year warranty on welds. On order, other colors, thicknesses, available The lifespan of a liner is 10 to 15 years. Liner 75/100th
|
Please note that this cover is tailor-made to order, there will be no return possible or withdrawal periods.
The reference to the CERLAND brand has the sole objective of guiding the buyer and in no case that of suggesting or inducing that the products described on this product page are identical to the original models registered and issued products specific to the CERLAND brand. The compatible or generic product that we offer is French manufacturing from our customers' plans. They have no link with the CERLAND brand. However, this exchange in no way exempts the consumer from complying with the recommendations for use set by the swimming pool manufacturer, particularly in terms of upkeep and maintenance
The ideal temperature for the installation of a liner is between 18° and 25°C.
63 -- Place the liner in the center of the pool and unfold it. When unfolding, the liner forms an octagon on the ground
regular or elongated depending on the pool, which facilitates its positioning in correspondence with the angles of the pool.
Get in inside your pool barefoot and engage the upper profile (the lip) of the liner in the attachment rail
and continue progressing around the pool.
When When in place, hold the liner in the corners and at regular intervals using wooden half-clips inserted (not supplied) between the liner and the hanging rail. This operation will help you position the
linge en bois insérées (non fournies) entre le liner et le rail daccrochage. Cette opération vous aidera à positionner le
liner and prevent it from sliding in the rail. Maintain this device until your pool is completely filled.
Check that the bottom angles of the liner wall match the angles of your structure. You will notice
during installation that the liner is smaller than the structure, this is completely normal and necessary in order to obtain
good tension once it is installed. put in water. The reductions are approximately 1% on the periphery and 5% in height.
Make sure it is correctly distributed over the entire surface of the pool.
Laissez le liner en létat le temps que le soleil atténue les plis liés au pliage du produit.(quelques heures sont nécessaires)
65 -- When the liner is perfectly attached and in place, fill the pool with only 2 centimeters of water. Push the folds of the liner from the center towards the walls as much as possible. Pay particular attention to carrying out this operation as it guarantees a background with as few creases as possible. Once the creases have been removed and after having ensured good positioning of the liner and its good adhesion, continue filling up to 10 cm below the outlet. |
66 - Place the adhesive gasket on the nozzle body flange. 67-Locate through the liner the 4 screw points of the nozzle body.
68: Screw in the flange equipped with its adhesive seal using the FZ M5x16 stainless steel screws from the skin part to be seal. During this operation, be sure to alternate tightening to ensure a perfect seal. Favor manual tightening to avoid too brutal tightening which risks splitting the flange.
69 Cut out the delivery nozzle. Using a cutter, carefully cut the liner using the inside of the nozzle body
Otherwise the liner will be too rigid or too flexible and will be very difficult to put in place. In very hot periods, choose an installation
at the very beginning of the day. On the contrary, if the temperature is quite low (below 18°), keep the liner warm for as long as possible to soften it, taking it out only at the last moment before installing it| ||1994
plus longtemps possible pour lassouplir en ne le sortant quau dernier moment avant deffectuer la pose